inav

inav copied to clipboard

iNav 8.0.1 reports NO RC LINK when one exists via DJI Air Unit, and intermittently fails to arm and disarm

1

## Current Behavior Power up the quad, DJI Air Unit, DJI controller. Attempt to arm, but OSD intermittently shows "Unable to Arm, No RC Link". Once link "stabalises" and quad...

undiplomatic

Airspeed telemetry for CRSF (originally issue #6200)

4

> Airspeed is not in the CRSF protocol. Please reach out to TBS to add it. _Originally posted by @OptimusTi in [#6200](https://github.com/iNavFlight/inav/issues/6200#issuecomment-2138345266)_ Since version 3.5.5, airspeed is now implemented in...

viennalex76-alt

PID Tuning for 6 inch Deadcat

1

I recently built a 6 inch deadcat cinematic Quad with I nav 8.0.1 but I am having Lot of propwash can someone help me with it My quad configuration is...

animesh-tech

## Current Behavior Add new target for hglrc spector f722 pro fc (betaflight target:hglrc f722 mini) ## Desired Behavior ## Suggested Solution I read about how to request new target....

jun-k-hi

Expose full pose estimate via MSP

1

## Current Behavior [3D attitude](https://github.com/iNavFlight/inav/wiki/MSP-Messages-reference#msp_attitude-108--0x6c), [estimated altitude](https://github.com/iNavFlight/inav/wiki/MSP-Messages-reference#msp_altitude-109--0x6d), etc., are exposed via the MSP protocol. However, a full current pose (3D attitude and local/global position) estimate, along with 3D velocity, is...

yakorch

Add new target to Inav : BetaFPV F405 boards

1

## Current Behavior no target for BetaFPV F405 FCs, iNav has targets for BETAFPVF411 and BETAFPVF435 though they are less common ## Desired Behavior Add as target BETAFPVF405 ## Suggested...

etsach

Fixed-wing Angle mode, after flying normally for a while, the pitch axis suddenly dives down without warning, completely out of control.

10

In iNav 8.0.1 fixed-wing Angle mode, after flying normally for a while, the pitch axis suddenly dives down without warning, completely out of control. ## Current Behavior At 3:46:787 in...

cooljam

Add ADC channels to programming framework

4

Not sure if it's even possible, but it would be nice to have access to the raw ADC channels in the programming operand tabs so we could use that voltage...

dcan999

AHI/AHRS/Angle mode failure after about 1 to 3 minutes

13

Follow up on : https://github.com/iNavFlight/inav/issues/10943 Since I posted in this previous BR, I replaced the FC with the same make and model, and replaced the GPS, didn't change anything. Both...

OlivierC-FR

Calibration failing (sequence that does work is not as described)

6

Latest version 8.0.1 iNAV Configurator/Firmware (Matek405TE), Matek F405 HTE, O4Pro, M10Q-5883, Matek diversity Rx. (No specific firmware target is listed for the H version but its only difference is an...

BadRaven