inav

inav copied to clipboard

New target: AtomRC F405

2

This is the non-NAVI version of the AtomRC F405. Tested against an AtomRC F405 Exceed DJI: https://manuals.plus/atomrc/f405-35a-aio-exceed-dji-mini-fc-manual

robhaswell

Added Target JHEMU JHEF405A AIO with build in ELRS Serial RX, Baro and BMI IMU

20

target for the GSF405A-BMI AIO from jhemcu tested with GPS, DSHOT600, MAG, BARO and ELRS, working with no issues.

ltwin8

Support for AIKONF7 FC

1

Adding support for AIKONF7 Flight controller. Tested: - all sensors work fine (GPS, Compass [HGLRC M8 Pro], Baro(External BME280)) - Multiple flights and few RTH.

bhavpreet

Add UART2 Add ICM42605 gyro which is compatible with ICM-42688-P gyro on this FC

wchnflr

## Current Behavior If you load and apply Octo X8 mixer profile, you end up with 6 motors, instead of 8 ## Steps to Reproduce 1. Load Octo X8 mixer...

mmosca

Barometer Altutude telemetry not sending to the radio

20

## Current Behavior I can't get Baro Altitude telemetry to my radio TX16S (EdgeTX 2.9.4) I have a drone Betafpv Pavo20 with FC: F4 2-3S 20A AIO FC V1 (STM32F405RGT6)...

tifoha

Add a template for new target PR

2

This is a test template for new target pull requests. This adds a checklist for target validation to the PR.

mmosca

Servos Freeze when both sticks moving, even when Armed using INAV 7.1 on Speedybee F405 Wing with FLYSKY i6X via IBUS

8

Thanks in advance for any assistance... I have been trying to figure out this issue for over a week with numerous configurations and re-writing clean firmware to the Speedbee F405...

drxOne

Use 2 bits for msp displayport font page

1

May allow for future 4 page fonts

mmosca

Option to send airspeed instead of gps speed for CRSF radios

6

## Current Behavior There isn't an option for this and you are stuck with GPS speed on CRSF/ELRS on the radio screen ## Desired Behavior **Being able to change the...

juanxli