inav

inav copied to clipboard

Add new target CSKY405 and fix BMI088 driver

3

I have added the configuration file of the board that our company produces. I also added the ability to set the address of the BMP388 barometer, since in my case...

AlexandrShipovsky

ACRO Mode should not apply an automated Landing Procedure

19

## Current Behavior I like RTH Procedure of INAV, especially the final Controlled Landing Phase. I set nav_disarm_on_landing = ON. I decided to set nav_land_detect_sensitivity = 6 just to improve...

Tonynux

no sdcard found Beerotor F4

6

## Current Behavior SD card: Startup Failed ``` INAV/BEEROTORF4 7.0.0 Dec 5 2023 / 09:37:23 (895a4f31) GCC-10.3.1 20210824 (release) System Uptime: 120 seconds Current Time: 2041-06-28T01:04:00.000+00:00 Voltage: 0.00V (0S battery...

guerradr

DzikuVx

Change SmartPort sensor IDs for GPS and Modes

1

The current implementation of INAV SmartPort telemetry uses temperature sensor IDs for Modes and GNSS data. This causes issues on transmitter firmware that more strictly adhere to the telemetry ID's...

MrD-RC

VTX data not saved

1

Running HDzero freestyle V1 vtx. When i save (under Configuration tab) the vtx settings are shown as saved. But when i power the drone (7inch) up, are set to Boscam...

zpust00

GPS ON/OFF setting only switch nav-features but not telemetry/monitoring

6

## Current Behavior `feature GPS` fully disables all GPS functions, including Telemetry and OSD Monitoring ## Desired Behavior It would be better if `feature GPS` would only disable navigation features...

b14ckyy

HUD home position constraint

4

I was testing @MrD-RC's new ESP32 radar updates. Really nice work !! When I ventured out to test the rest of the HUD features as shown here.  I stumbled...

rts18

Incorrect throttle mid range with reversible motors

30

## Current Behavior With reversible motors enabled, the throttle range to allow arming on my plane is 1550 to 1650. ## Steps to Reproduce 1. Apply the above settings for...

pguillory

Runcam Split 2S not work with MambaF405mk2 FC

2

## Current Behavior No Wifi, Power and Change mode button features enabled after FC and runcam power up. Uart5 used for connection, 115200 baud rate, runcam device enabled in Ports...

FLahner23