inav

inav copied to clipboard

Motor #1 doesn't rotate when the craft is armed with Multishot protocol. [Speedybee F405 v3]

1

Stack: Speedybee F405 v3 50A BLSheli ESCs Form Factor: 5 inch quad, no FPV system, 2300kv motors, 4S 1550mah batteries, Radiomaster TX12 MKII ELRS Transmitter. Issue: with Multishot protocol selected,...

johndoe422

MSP2 over crsf done like betaflight

15

I have implemented MSP2 over CRSF for the lua Script (so we get a lua script for Inav also. https://github.com/betaflight/betaflight-tx-lua-scripts/issues/491 MSP2 over crsf done like here: betaflight/betaflight#11112 betaflight/betaflight#11131 I now...

druckgott

terarange evo lidar

1

Hi, it's support for teraranger evo family lidars. Rangefinder contains two interafaces, serial and I2C, I decided to use I2c becasue it's better use UART for more clever devices. TeraRange...

error414

Hello, could you please advise me how to set it so that I have 3W power set on the vtx. When I try to set it up, I have a...

spajkr

The beeper ouput pin is blocked by deactivated sources, other sources that are not deactivated cannot activate the beeper

1

## Current Behavior Although the beeper is switched on via an RX channel (Mode Beeper), the beeper output-pin does not work if, for example, the setting "beeper -HW_FAILURE" has been...

1972linux

Emergency landing "resets" when barometer altitude reads 0m, BAD on downward sloping terrain: will never land

10

## Current Behavior When flying without a GPS lock and a radio failsafe happens, instead of engaging RTH mode, Inav enters into emergency landing mode. That's ok, because without GPS...

rmaia3d

3D flying - hovering - torque roll - holding flight attitude

2

## Current Behavior As Wing pilot, flying "3D" in AGRO is nearly impossible, so I switch back to manual mode to have 3D fun. The FC is doing it´s job...

DM4DS

I am getting a NO DATAFLASH CHIP on INAV 7. Getting this on both of my Speedybee WIng. One is brand new. Blackbox is enabled with SD cards. This just...

FarmboyFPV

When HITL plugin is used with SITL, plane is "dolphining" in navigation modes. Actual problem is that accelerometer/gyroscope data from simulator is not processed at all. Fixed.

RomanLut

MSP2 over Crsf Telemety for PID lua Script like betaflight

5

## Current Behavior MSP2 is currently not Supported over CRSF Telemetry so we cant use lua script to change pids with transmitter ## Desired Behavior MSP2 is supported over CRSF...

druckgott