inav

inav copied to clipboard

Expanding view for the osd window

2

Is it possible to have a 'hover over widget / button' to temporarily magnify the osd centre window? Like a pop up? Hover over to magnify. Like Amazon images on...

oldrootbeer

Dshort is not working with T-Motor F722 (Not V2) there is a DMA Comflict Solution : Add Dshot300/600 for this board FC Board name and vendor: T-Motor F7 with STM32F722...

Pi-wi74

## Current Behavior After EZ Tune has been enabled the stick command menu (cms) still shows regular PID Tuning options which should not be used anymore and are only deactivated...

materia79

Extended CLI Status Report

1

## Current Behavior ## Desired Behavior Add the current installed firmware name and user selected ESC protocol to the CLI status report. ## Suggested Solution ## Who does this impact?...

Phil-MC

Onboard Takeoff Push Button For Large Fixed Wings

10

## Current Behavior : To take off in AutoLAUNCH mode, with the remote control on the ground, for a larger aircraft that requires a two-handed grip on the fuselage, the...

gaaryz

## Current Behavior Configuration Button doesnt configure sensor. ## Steps to Reproduce 1. Hardware Benewake TF Mini Plus (range finder) 2. Matek 3901-LOX optical flow and rangefinder 3. Flight Controller...

anselbear

The idea here is to unlock the possibility of integrating [AssistNow](https://www.u-blox.com/en/product/assistnow) functionality in the configurator. Configurator can fetch AssistNow data over the internet and send the data over MSP to...

mmosca

The current 0.35hz LPF is introducing too much delay on airspeed. change the default value to 3HZ Add option to disable virtual pitot by setting the frequency to 0. Should...

shota3527

Added target FLYWOOF405NANO

36

Hi team, in collaboration with Flywoo dev team I've created the GOKU GN405 target. Target name FLYWOOF405NANO This is the board: https://flywoo.net/collections/explorer-lr-4-part/products/c702-goku-gn405-nano-13a-stack-w-4pcs-ws2812-led-16-16 The code has already been tested on a...

sdellava

Improve safety reading QMC5883 compass

3

## Current Behavior In case of incorrect readings of the compass after it was initialised the values are reset to 0. this might cause strange reactions to the drone. ##...

IgnacioHR