inav

inav copied to clipboard

Questions about NMEA protocol

3

As we know that in INAV7.0, the NMEA protocol is not supported anymore. Only the UBLOX series protocol is supported and we have to use the UBLOX based gps module....

do1234521

Hi, I am designing/building a 3D print sub250 flying wing. - wing span = 520mm / 9dm^2 - weights about 250g - speed up to 90km/h in today's fly -...

majianjia

lida2003

Autolaunch behavior of elevator Ruder during throttle rise

4

## Current Behavior If you have switched on autolaunch the elevator is moving down. Then you rais the throttle to idle speed and parallel the elevator is moving upwards (slow)...

druckgott

Updates to disarm save delay and emergency rearm

3

Initial changes

MrD-RC

QNE Altitude - is altitude without binding to Home point alt. In need for several situations: - distinguish your altitude from the altitude of the aircraft using ADBS data on...

r1000ru

Wiggle to wake launch idle

1

This PR adds an alternate, or additional method to start the autolaunch idle throttle. Using this you can wiggle the yaw of the plane to start the idle throttle. This...

MrD-RC

As discussed in the #Dev-Team discord channel, the Quick Median Filter added in the past has quite poor performance. This PR has the purpose of replacing the old/current media filter...

JulioCesarMatias

Create new target FLYWOOF405S_AIO_PINIO

2

This new SKIP_RELEASES target replaces the WS2811 LED_STRIP functionality with PINIO to control the neon LED output or other output on PA9 via USER1 in Modes. Betaflight allows reassigning resources...

wchnflr

Increase the number of controlled LEDs ws2811 strip to 96

12

The iNAV firmware currently allows up to 32 ws2811 controllable LEDs. Since many people use this iNAV firmware on aircraft. To make a beautiful backlight, 32 LEDs are not enough....

TrueMuMa