inav

inav copied to clipboard

Engine burned after RTH procedure started

9

## Current Behavior After crash and lost rx signal, failsafe RTH procedure starts engines and try to fly back home, but it is not possible because quad is stuck in...

Macianno

Zero distance after Gps lost and restore

11

While flying INAV 7.1 and Gps lost (sats=0) and back to normal (sats>0) distance is zero. Examples in video : https://youtu.be/6rszFYM9t9I There was no this problem in INAV6.1 Just appeared...

Zimenkov

via the MSP_VTX_CONFIG command

bkleiner

enable MSP override build flag by default

2

I think this is safe to allow by default by now, a minority uses it but the chances of someone accidentally sending MSP RC commands is probably slim to none

xznhj8129

How to Control an iNav Drone with MAVLink and Raspberry Pi: Setup and Configuration Guid

1

Hi everyone, I’m working on configuring an iNav-based flight controller for my drone and aiming to control its movement using a Raspberry Pi with the pymavlink library. I’ve already connected...

Alikavari

GPS not working in NEUTRONRCF435MINI

8

## Current Behavior Just made the switch from Betaflight and the GPS is not working (was fully working in Betaflight) is wired to UART2, GPS is BK-880. The GPS icon...

giou

Engine armed alert on MAVLINK receiver when plugged in via USB

2

## Current Behavior When using MAVLINK receiver, the controller (TX12) will give the "engines armed" alert when the craft is unarmed on USB power and scream about critical battery and...

xznhj8129

F4 1S 12A AIO Brushless Flight Controller V3

2

This board is full of features for a very light design (4.2g), as an integrated serial elrs 2.4 rx, 2 serial ports, 12A esc, baro and efficient MCU, it would...

CorvusMonitoring

BEEPER -ON_USB not working

6

I've been setting BEEPER -ON_USB via the CLI for many years but on the latest few versions of iNav, the beeper continues to beep while the FC is only plugged...

mrduncan626

SKYSTARSF405HD4 Change timer for S5 S6

4

## Current Behavior I use SKYSTARSF405HD4 FC and want to use 4 motors(S1-S4) and 2 servos (S5-S6) But its badly assigned to Timers like S1 Timer4 S2 Timer4 S3 Timer3...

Yarolsav180703