bdring

We currently don't support encoders, so adding lathe features that require that would be a big project. It is also hard to develop such things when the primary developers don't...

I set $Report/Interval=100 and it reports feed override every tenth report or immediately after any change to the override. ``` f - ``` It does not report the new value...

Show what happens when you try to home with `$H` in the latest version of the firmware with '$message/level=debug' . Use fluidTerm or the web terminal Use the web install...

It sounds like you have some non standard hardware issues. You should explain that setup to us.

Let's fix the start errors first. I see an error in your config file. For the Huanyang, the uart parameters are not indented under the uart: line. This causes all...

You should create a wiki page for this. You can just include a markdown file here or create a page on the official wiki. http://wiki.fluidnc.com/en/wiki_contributions

We have talked about adding that feature in the past. I have added it to [our informal list](http://wiki.fluidnc.com/en/development/open_issues#allow-jogging-off-active-switches). It has never been a high priority because after setup most people...

We have talked about a similar in the past. Since it is a common solution built into Lightburn, we might consider this approach. It will take a while to implement...

I think Lightburn should create a written spec for it. I have seen a few posts on it but not the complete story. LIghtburn "pixels" and FluidNC steps are not...

It seems pretty simple. We may be able to simply translate the lines on the fly and optimize a bit. G91 x1.364s800:800:0:800:800:800:0:0 The 8 “pixels” are 1.364/8 or 0.1705 each....