bdring
bdring
That is not technically a 6 Pack. It is a 6x which does not have the plug in modules. No jumpers to worry about on this controller. - Do the...
If the correct step LEDs glow during the motion, the controller is setup right. The signal that goes to the LED also goes to the driver. Are you sure the...
All motors lock during any motion. Many people will set `idle_ms: 255` to keep motors locked at all times. This prevents drift between moves. You can always unlock with `$MD`...
I think the LED might turn off if you use anything in the 16-31 range. Try adding this or change the number to the actual offending LED pin number. ```yaml...
The LEDs actually helped a lot here, because we knew the problem was outside the controller.
We don't have a good way of doing that at this time. We had a long discussion on Discord and decided it is probably best to use a UPS. Even...
It would not go the wrong direction, but could misread the pulse. It acts on the wrong side of the pulse. It is unlikely the issue, but worth checking. Do...
Try looking for led activity in both active modes. It is really hard to see fast off blinks.
That is excessive. It could be a problem at high speeds. Most people use 80 to 100 steps per mm.
I don't know. I'll stop speculating. I will test next week.