bdring
bdring
I don't follow your question. Here is the wiki page. http://wiki.fluidnc.com/en/config/probe Here is an example ```yaml probe: pin: gpio.34 toolsetter_pin: gpio.14 check_mode_start: true ``` Initially there was only one pin....
There are a few items that broke our naming convention. Many things and sections evolved over time. There are many things we would love to change, but breaking thousands of...
If you have questions about FluidNC, it is better to ask on the FluidNC github repo. More people will see it there. We also have a Discord server with a...
The buttons on the Webui are overrides. Send M7, M8 and M9 from the console.
Are you always running via the WebUI? Can you try running via a serial port sender or by starting an SD file using FluidTerm. Do not have the WebUI loaded...
It is possible something is causing the WebUI to reload during a job, like a refresh from a wakeup, etc. That can mess up the timing. The next version will...
That is not the startup messages. See the wiki on how to show the messages.
It seems like you could do what you want with the proper nesting of if statements. With that said, the fail case is an important one. Currently gcode or FluidNC...
Closing old issues
- What stepper motor drivers are you using? - How are your jumper configured? If you only use i2so numbers less than 16 the controller is not actively setting the...