bdring

Results 480 comments of bdring

Problem: gpio.14 (integrated esp32) does not change state. Plasma branch f/w.

Yes, but the new code would do an error check before sending the enable signal. If the arc_ok is on ***before enable***, it would assume there is a error in...

Problem: gpio.14 (integrated esp32) does not change state. Plasma branch f/w.

What is the arc ok input connected to? Do you understand how the arc ok input works?

Problem: Problem getting the configuration in Openbuilds Control v1.0.364

Something is requesting status during the reading of the config. Status is an immediate command. Those commands have the highest priority in the system. We do not want to block...

Problem: Stepper motors not moving

What are the power supply specs?

Problem: Stepper motors not moving

Try leaving all chips installed and disconnect all motors, but 1. The 5160 is notorious for current spikes. I suggest at least 4 amps per motor regardless of current levels...

Problem: 6x cnc controller motor 5 and 6 do not work

Please add the start messages

Problem: 6x cnc controller motor 5 and 6 do not work

The start messages are a beautiful thing.

Problem: Limit switches trigger on noise and not on TTL 5V to 0V (i think)

Closing stale issue

Problem: How Setup Servo Motor - StepperOnline Model A6-RS750H2A1-M17

Do you mean you want a dual motor Y axis?

Problem: How Setup Servo Motor - StepperOnline Model A6-RS750H2A1-M17

You need a motor0: and motor1: for the Y axis. There is an example of a XYYZ config here. https://github.com/bdring/fluidnc-config-files/blob/main/contributed/6x_CNC_Controller/6x_xyyz_pwm.yaml You can use any of the motor driver outputs for...