bdring
bdring
I prototyped a bit of a new case concept for the 6 Pack. I wanted to keep the flexible, modular concept. If you change out a module, you shouldn't need...
Here is a simple CNC I/O Module to add a couple of RC servos or a BESC (Brushless Electronic Speed Controller). It has a switch to allow the servos to...
I added a 3D STEP file in the [3D_Files](https://github.com/bdring/6-Pack_CNC_Controller/tree/main/3D_Files) folder  Step files of the modules will take a little time.
The MP1584EN power supply IC obsolete. I have been using it for years and did not notice it until recently. My PCB supplier has no trouble getting them though. I...
Testing of version 1.0 went great. There were no real issues with the hardware. I made a few small tweaks and released 1.1 for a small production batch. - Tented...
A new version has been designed, added to [the repo](https://github.com/bdring/6-Pack_CNC_Controller/tree/master/versions/V1p0) and 10 samples ordered. - Fixed issue where StepStick and SD card conflicted. - Switched from (2) spindle modules to...
Add an optional "P" parameter that specifies the thickness (or offset from 0) of the probe device. Upon successful probe the offset of the current system is zeroed with the...
I created a new revision of the controller based on some input in this forum. New Features - Uses same firmware (no i/o changes) - Has an alternate connector location...
I have tested [this power supply from Alibaba](https://www.aliexpress.com/item/33034496914.html?spm=a2g0s.12269583.0.0.255713f1OnfaJm) and it works fine. It has a variable output rather than a fixed one, so it does need to be adjusted. ...
I have a small batch of midTbot controller kits available on [Tindie](https://www.tindie.com/products/33366583/midtbot-esp32-v1-controller-kit/). 