Stuart Pittaway
Stuart Pittaway
About that yes. The JST connect is rated up to 2amp but I would not put that through them.
The dump load shouldn't be triggering that frequently. It's active high, so held low by the pull down resistor. If the module isn't connected to the controller, every 8 seconds...
How strange, I'll have to dig out the scope!
Would it not be easier to change the code just to remove the PWM signal? You wouldn't need all those large caps. I'm still intrigued on the need to do...
The PWM is there for a reason, it keeps the temperature of the module down to the set level. If you don't need that, it's fairly easy to just switch...
Yes it's the same code and almost identical circuits
It was so long ago I cannot remember! I've been working on v4 since.
Connecr the two pins together marked wifi reset.
Did you reboot the esp after joining the pins together?
Ok. You could reprogram the esp chip, that should clear it's settings