Stuart Pittaway
Stuart Pittaway
Confirm that I also get this bug with d1 mini pro - 128mbit flash Pretending the mini pro only has 64mbit of flash works board_build.ldscript = eagle.flash.8m7m.ld
How would you expect this to work, by "force balance" of the highest cell voltage to bring the average down ?
Have you used this on the esp8266 previously? The code was merged from 32 to 8266 to try and maintain some resemblance of similarity, but I didn't publish that it...
I'm not saying it shouldn't work, but its probably not been tested/used!
See issue 10 in the other GitHub repo.
Do you not yet have the controller PCB?
https://www.avrfreaks.net/forum/losing-eeprom-value-after-few-days
Thank you for the video, I've built a test using 4 modules and 1 controller, but I can't get the warning message to appear. Can I ask you to reprogram...
Okay, got to the bottom of this one. The controller expects each module to match the "global setting" temperature, if any module doesn't match then the warning is thrown. To...
V420 boards have a maximum temperature of 45 degrees due to design fault as explained on other post - only use the V420SWAPR19R20 firmware if you have unsoldered and swapped...