Temp calibration

Open hepike opened this issue 6 years ago • 2 comments

Hi,

After I calibrate manually the temperature on the modul site, then the voltage goes to zero. Without calibration it shows much higher value, so I need to calibrate somehow.

I use the very latest version software both on my esp and on the v3.0 modules.

Thanks.

Apr 07 '19 19:04 hepike

Did you ever solve this? I had a similar problem that also I think resulted in that same behavior but I think I may have fixed it in my fork of the Controller. I had a NaN issue with temperature conversion and it was causing problems

Jan 27 '21 22:01 acidice333

It was so long ago I cannot remember! I've been working on v4 since.

Jan 27 '21 22:01 stuartpittaway