John C

Apparently this is being caused by a call to 'update part resources' from the ModularRCS part-module, which normally interacts with a 'VolumeContainer' on the part. When VolumeContainer is not present,...

> I am seeing something similar with the GEN - ISDC - Interstage Decoupler. In particular if I set the solid fuel level to anything lower than full, it defaults...

Yes and no. You can add a static amount of lift through the part config. I do not think that I can manipulate it at runtime though so that it...

I would not put the onus for solving this problem purely in the hands of MemGraph. It is great for what it is, but it is not a silver bullet...

Thanks for the confirmation and offer. Unfortunately I think it is merely going to come down to me spending some major time doing playtesting and debugging -- no real other...

Stock wheel patch updates - WIP -- need to do spreadsheet balancing of all of the parts in regards to motor output. Not quite sure where to start on the...

Increased mass is intended, and yes, I believe the 'heavy' should have about 2x the 'dry mass' when compared to the 'medium'. Now... that isn't to say that the starting...

I've simplified/unified the mass and volume calcuations for the ModularHeatShield (both module, and part) for the 1.4 rework. Mass and volume are now calculated from the model definition specifications for...

This is being caused by model definitions for adapters/etc lacking FAIRING definitions. It is the fairing defs that determine placement of the interstage nodes. Will need to investigate the best...

To test -- does the KF-TrackSimple exhibit these problems? It is rigged in such a way as that wheel colliders will be oriented in the same direction when the part...