sfeakes
sfeakes
Can you log to a file, and post that.
This below line shows that AqualinkD (and OS) is detecting a FTDI chip and setting everything according. But that doesn’t prove it’s not a clone. But you should be good,...
In your log, I can see you turned the pump off and it worked, then tried to turned in on and it failed and got a serial error. So from...
Thanks, I’ve never seen that specific panel REV before, and it gives a very slightly different connection message to other panels on initial connection. I will need to post an...
I just posted an update, that should fix AqualinkD not going into programming mode on startup. if you used the `aqua.sh` script to install, you'll need to run it again...
@ballle98 Yes, their is a lot of work done around using IAQ touch for PDA panels that support that protocol. I basically decided it was best to move the whole...
Using 0x33 as the main ID, is not ready for prime time, (message above), hence it’s not documented in wiki or config. There is a lot broken / not fully...
On the pump, have you added it to aqualinkd.conf? Assuming it's the filter pump, you should have an entry like this ```button_01_pumpID=0x78``` I don't believe that bacd packet is from...
I think you are right, the 0xa3 is one of the address the iAqualink2 uses. I haven't managed to get my hands on one of those to debug it yet....
Glad you like the changes. I didn't even know they made an RS4 panel, (or I forgot). Your spa/pool heater buttons will almost certainly be incorrect in the config. My...