sfeakes
sfeakes
You could try swapping A and B it won’t damage anything. Did you try to connect after powering up the chlorinator? According to the manual it will only try to...
RS485 as a protocol is supposed to be good to something like 4000 ft, but no way you can go that far with the power. I'd say 40ft probably about...
You’ll have to compile it for Ubuntu as it’s comes compiled for the pi. Just run ‘make clean’ then ‘make’ from the director you downloaded AquapureD into. You’ll probably also...
My mistake, it should be `make aquarited`, not `make`
In the Jandy (& Pentair) protocol, the master RS485 device sends a Probe to a specific ID, and if a device at that ID is alive, with sends an ACK,...
Few thoughts. 1) Power could be an issue, I'm really not sure what the Trick expects, this software was what I used to control Aquarite SWG (which uses Jandy protocol)....
@Kranzy. Yup, I've read that. That is all about how to mimic a keypad to control the RS485 master, same thins AqualinkD does. This (Aquapure) needs to mimic the RS485...
I assume it’s reading low in the web ui? Can you set logging to debug, let it run for a few minutes and post the log.
Thanks for the logs. Between 2.2.x and 2.3.x the code that reads the RS485 packets has not changed. I've gone over the code in detail and the only change that...
Thanks for the log, I can see in their that the control panel is sending pool temp as 2 deg F. So very odd. I also notices that the iAqualink...