sfeakes

Someone else had / just reported this exact problem, and I believe at the exact same time. (48 min passed the hour). I wonder if you are both on the...

First error (below) is the main issue. you need to change that to something valid. So you need to edit the config. Error: Unknown config parameter 'device_id=0x0'. But first, I...

Jandy (and many pool equipment manufactures) seem to try to confuse people with their products & names...:). But from the board (label on the chip), that's a PDA only board....

If you can make it work without PDA mode, I highly recommend going that route. Again, serial_logger will tell you what ID's the panel is probing for, and if anything...

You have to be careful on the version / revision board you are buying. $299 is **probably** an older rev# and while will work perfectly with AqualinkD, (better than PDA...

@awshifts Yes you should. Again depending on panel support. AqualinkD can either use the panel to program the lights (if the panel supports the lights you have, and that will...

Yes turning anything on/off is instant with all RS board. Changing heater set points / SWG % / VSP speed can take some time though. The amount of time will...

First you must tell the panel it's a normal light if you want Aqualinkd to to the programming. Then configure the option of how to control the light in /etc/aqualinkd.conf...

This is an interesting one. I just realized The debug messages for send data are messed up in 1.3.9, so that’s what’s making you think it’s not sending a reply...

I've posted 1.3.9a, it may help with debugging this problem.