sfeakes

Perfect, I’ve decoded the brightness commands but it looks like it missed the light change color commands (and maybe the off). Can you run through changing the light colors again...

Oh, and one other thing (in a different log). Can you set the same RS filters. Then turn the light to fully RED, then GREEN, then BLUE. Thanks.

Thanks for posting that, very helpful. > Also, I have not found a way to control the lights at all (other than on/off) via the web interface, only the mobile...

@christiaanbrand can you please list everything on the RS485 bus, including all keypads. You were using Aqualink Touch ID (0x31) for extended programming, you said you tried other IDs, did...

The Jandy protocol has no from in the packet, so if something is sent late, ie out of order it has no way to know. It’s not the SWG that’s...

If the control panel doesn’t sent “heart beat” to SWG then the SWG will go into manual mode, and I think this maybe what’s happening. Control panel getting messages out...

In your config, you have some ID’s commented out, you should I comment and set these appropriately. ``` # device_id=0x0a # rssa_device_id=0x48 ``` Can you try disconnecting your one touch,...

Unplugging the OneTouch, leaving it unplugged, and starting AqualinkD didn't work? I was looking over your logs and thought maybe I had an idea of what was going on, but...

I think I have tracked this down, it's actually a bug in some versions Jandy firmware. I'm just not sure how to fix it yet. Well I can't fix it,...

@christiaanbrand @niharmehta I have just updated AqualinkD to version 2.3.3 and think this may have been fixed. If you pull the latest version and add the below to aqualinkd.conf ```rs485_frame_delay...