marqs85
marqs85
does the red LED stay on in A-LM mode?
I discovered a different issue which result to vertical jumping if H and V syncs are very closely aligned. This is on FW side and was easy to fix. Is...
Most likely that wouldn't need additional block RAM and could just utilize data from a couple previous samples stored in registers. The end result would probably depend on sampling rate...
This error indicates the very first I2C probe fails. The access is made into THS7353 chip, but there may be something else shorting SCL/SDA line into ground. If you don't...
Have you tried applying the modification detailed [here](https://videogameperfection.com/forums/topic/dexx-vd_isl-horizontal-jitter-in-scaling-mode/)?
It's highly recommended since the blob connects one GPIO pin (potentially output with some other application running on DE10-Nano) to GND.
What do you mean by being not supported, not syncing at all (e.g. no stable numbers on the front LCD) or nothing displayed on the connected monitor? 17kHz @ 50Hz...
I just tested the following generated MDA-like modeline via PC which did work: `Modeline "720x340_49 (MDA)" 15.126 720 738 873 882 340 341 344 350 -hsync -vsync`. The problem might...
The modeline was just a sanity check whether a 350-line input signal will match a preset which it did. A new MDA preset could be eventually added on the firmware...
Wouldn't that mean 18147/49.04=370 lines? Sync polarity shouldn't matter, but I've not really tested much with sources with positive polarity.