marqs85
marqs85
Neo Geos (especially MVS) have lower refresh rate than standard 59.94/60Hz sources. They also output 264 lines instead of typical 262/263. There's very little OSSC (regardless of HW revision) can...
Pro is able to normalize line count to CEA standard, and also refresh rate to 59.94/60Hz if needed.
Board revisions from 1.6 upwards have protection diodes on HDMI so electrical damage is unlikely, but mechanical damage/weakness on the connector is still a possibility.
Not sure if it helps, but [here](https://circuit-board.de/forum/index.php/Attachment/213551-PAL-snes-1chip-schematic-pdf/) is schematic to SNSP-CPU-1CHIP-01/SNSP-CPU-1CHIP-02. For pictures you need to ask someone who has installed it into one of these.
I'll consider adding this for next v1.xx series firmware. For OSSC Pro vertical sync polarity could be set separately to differentiate between x350 and x400 modes since it already has...
Some CTI settings exist in the video decoder chip, perhaps they can be exposed in the next firmware.
CTI options were added in 97ba1931642764354c842c019f9e1d786606f210.
Perhaps a duplicate of [this](https://github.com/marqs85/ossc/issues/112)?
Which display is that, and do you have another source that works in Freesync mode at 2560x1440? In the latter case, is there any chance you could extract the SPD/vendor...
The video signal is identical with VRR setting on and off, only the metadata changes. It might be that the display supports VRR only on certain pixel clock frequencies (usually...