DanielGeA
DanielGeA
Not sure if opentx/edgetx lua scripts are compatlble with ethos.
Ok. I'll fix that. Do you see the telemetry in the transmitter?
It is I2C protocol. Red wire is SCL, yellow is SDA and black is GND. I'll update this in the docs.
Added wire colors identification with [commit](https://github.com/dgatf/msrc/commit/2a7a276d9aa52f3a786ef0e141476736ed4c9701). Please let me know if it works with MSRC.
Ok. This is what I'm getting with an arduino mega as a receiver and temperature sensor enabled in msrc: 1. Circuit  2. msrc gui debug (in hex): `Hitec (239)...
If this doesn't work, capture the signal without the rp2040 or any sensor connected. In this case pullups are needed.
> Mr. Daniel GA, > > A test was conducted. The receiver is powered by the BEC power from the ESC. The PULL UP power source is the R2040's 3.3V...
> > Ok. I'll fix that. > > Do you see the telemetry in the transmitter? > > Yes, I get the telemetry from transmitter. This test was done with...
> When I set your Arduino Mega as a virtual receiver, if I turn on the RP2040 first and then the Arduino Mega, the LED inside the RP2040 will blink....
> Mr. Daniel Ga; > > > > I use 1kohm resistor for the pull up . > > > > > Best regards, > > Gorochan > […](#) Just...