DanielGeA
DanielGeA
Yes, you only need to select a different _Sensor Id_ in receiver protocol for each MSRC board. Connect both to Smartport.
> Electronic ignition systems from like an Da or Dle Do they output rpms in pulses or PWM or they use another protocol?
> I will try going with double boards and se how it works, i only have one smartport lead from the engine compartment but i think it should work anyway...
Yes, there was a mistake in the circuit image. PWM or pulses goes to GPIO4. Fixed with commit 02951b1. It uses the internal pullup of the RP2040 (50k). You should...
> hall sensor that drops its resistance to zero when passing the magnet on the flywheel Or you may need to use a pull down resistor. When resistance goes to...
Which hall sensor model is? Do you have the datasheet? If it uses a NPN transistor, you need a pullup. For a PNP transistor you need a pulldown. Usually hall...
Sure. I've just upload a massive update due to increasing the accuracy for the GPS and improving the serial monitor. This was a small change, but a lot of coding....
It is ok with Hott protocol and transmitter ON. MSRC is sending the packet, but the receiver is not reading it. It can be that is malformed or the circuit....
> Yes, HOTT packets are presented, but after some secods they disappears. Maybe because the receiver is not reading the packages. > I have resistor 120 ohm between GPIO0 and...
Only HEX format is needed. There is something odd with the crc. If you compare three packets from the genuine sensor, being the packets the same bytes, the crc is...