TMCStepper
TMCStepper copied to clipboard
teemuatlut
Greetings, I have been using the release version of this library in combination with the TMC2300-BOB. The breakout board is connected to a RPi Pico which is being programmed via...
It's possible to use up to 8 drivers with the ESP32 using 2 hardware serial and TMC2209 which can be set to differing UART addresses. But because the esp32 only...
Hello, I am using a TMC5160-BOB Breakout boards to control my stepper motor(17HS08-1004S). The breakout boards is configured to use the internal ramp generator. Currently, I am trying to use...
Hi I'm trying to use an Arduino to drive a TMC2590, specifically the version on the breakout board TMC2590-BOB40. Are any of the supported devices compatible with the 2590? I...
hey, im running a tmc5160 with tmcstepper on my teensy 4.1 with a nema23. I tried to tune my stealthchop frequency and soldered two wires to the R033 sense resistors...
In a [project](https://www.astronet.dk/forum/viewtopic.php?p=61761#p61761), where I have to drive an Alt/Az telescope mount with two NEMA 17 Bipolar Data sheet: https://www.dropbox.com/scl/fi/bamu2rfkfatrha0yyexck/17HS19-2004S1_Full_Datasheet.pdf?rlkey=6kmdzl3kiz0q1l13s2h8veds8&dl=0 I am building my project based on an Arduino MEGA...
Hi there I have just downloaded your library for TMC chips to use om my stepper setup. But 6 out of 8 examples in your library is now working out...
I recently started investigating using your library for a ESP32 based project I'm starting but could never get any of the UART based examples to work. After spending way more...
