Stuart Pittaway

Hi @PiotrSin, here is a controller firmware which should support up to 192 cells. I would start with a 16S pack/bank and then grow the cells as needed. On the...

> How can I support this project or buy you a coffee :) You can also send beer tokens via Paypal - https://paypal.me/stuart2222 How are you going to control over...

You can't program the V490 boards directly from the controller - they use the STM32 chip not the ATMEL ones found on the older boards. All the pre-compiled code is...

The calibration settings has no affect on the v490 module, there shouldn't be any need for calibration as the design uses higher accuracy parts. Why are your voltage levels so...

Kicad doesn't output the manual soldered part locations automatically. If you are only making a few boards, I'd recommend buying those parts from lcsc and manually soldering them on to...

That looks fairly destroyed to me. I don't have any plans to make any more of those boards as the new controller PCB has this built in, so no longer...

I did have 30 of them for sale in my shop, but all gone now. The jlcpcb files are all in GitHub, that's the same file I use to order...

Good idea - except do they may a 4.5V version of the MAX6129? https://www.analog.com/media/en/technical-documentation/data-sheets/MAX6129.pdf

Hi @chapulino. Attached to this message is the firmware with a code for forcing 16S configuration. This also uses the 10K baud/communication speed. Unzip this and then write the code...

> I'll definitely try it this afternoon and I'll report back to you. @chapulino I've found a bug for the 16S configuration - so please use the version on GITHUB...