Mark

Hi, the real time level and the mesh bed level can not be work together, so you can remove the `BDSENSOR_SET REAL_TIME_HEIGHT` and use the normal mesh bed level first...

Which port and gpio was the BDsensor connected to? the 10.24 means the board can not communicate to the sensor

For the EBB42, you can try to use the I2C port, and set the delay value 20. [BDsensor] sda_pin: EBBCan: PB3 scl_pin: EBBCan: PB4 delay:20 Unknown command: I2CBD means the...

I just tested on my EBB36 today, it works well. maybe you can check again the connection, and the connection should like this.    BTW, please use the...

The EBB can not communicate to the sensor because there is no data after M102 S-1 which cable do you use, could you take a picture of that. > Sorry...

this is the old type of cable that may have issue. and even cannot be detected by the multimeter. I would like to send you the new one, please send...

did you enable the collision_sensing? the endstop read command M119 will not work if the collision_sensing is enabled. you can check the connection first by `M102 S-1`, then putting a...

Hello, what's hardware version on the BDsensorM, there is a different of the SDA and SCL pin number between the V1.0 and V1.1, which you can see from the text...

the pin name should be configured as following for the BDsensorM v1.1 connecting to Octopus 1.1 with EXP1 ``` sda_pin: PE10 scl_pin: PE9 ``` 

did it home z axis success? normally, it will home z axis without problem but will take more time to touch the bed, also I am planning to reduce the...