EmuFlight
EmuFlight copied to clipboard
emuflight
EmuFlight is flight controller software (firmware) used to fly multi-rotor craft.
Jeti EXBUS receiver protocol doesn't seem to be working in EmuFlight. I'm new to EmuFlight, setting it up for the first time. Therefore, I'm not sure if this is an...
**Describe the bug** *Emu 0.4.0* Barometer not detected on Matek F722-HD or Matek F722-SE. **To Reproduce** Flash to the correct target. Barometer not detected when activated. **Expected behavior** To see...
**Target Name** `MAMBAF405_2022A` **Vendor/Model** Diatone Mamba MK4 F405 https://www.diatone.us/collections/flightcontroller/products/mamba-mk4-f405mini-flight-control-20mm-m2 **CLI dump or Unified Target** https://github.com/betaflight/unified-targets/blob/master/configs/default/DIAT-MAMBAF405_2022A.config
**Vendor/Model** `FOXEERF745V2_AIO` https://www.foxeer.com/foxeer-reaper-aio-v2-f745-45a-bls-bluejay-2-6s-g-439 **CLI dump or Unified Target** https://github.com/betaflight/unified-targets/blob/master/configs/default/FOXE-FOXEERF745V2_AIO.config Requested by @ evstyle on discord Needs BMI270 gyro
This is a bit of a weird one... according to most vendors, the correct target is "JHE405", however, no such target exists. There does exist a "JHEF405" target, but it...
* this is purely for test-build purposes. * the idea here is to make test-branches from other PR's and include this so that they are small enough for flash-memory
Enable OSD to be displayed through serial port Add OSD_displayport_device = MSP and displayport_msp_serial = into CLI.
**[Vendor/Model](https://www.getfpv.com/)** * Please provide the target name. e.g. `MATEKH743` * Please provide vendor and model of the FC. e.g. `Lumenier LUX H7 HD Ultimate Flight Controller` * Please provide a...
**Describe the bug** BeeBrainPro DSM target is not showing gyro or accelerometer info when flashing. **To Reproduce** Flash `BEEBRAIN_PRO_DSM` target to appropriate flight controller and connect to configurator. **Expected behavior**...
The resource mapping for this hex seems incorrect. The motor was spinning ok when it was on Betaflight. After updating to Emuflight firmware, although I've applied the resource mapping from...
