suspected resource mapping issue on "EmuFlight_0.3.4_VGOODRCF4.hex"

[hokowi]

The resource mapping for this hex seems incorrect. The motor was spinning ok when it was on Betaflight. After updating to Emuflight firmware, although I've applied the resource mapping from Betaflight cli dump, at least one of the motor is not spinning.

I've soldered the Crossfire nano wire according to this guide (bridging IBUS and use LED_STRIP as the TX) - everything works in Betaflight. Not sure if this affects the compatibility with the Emuflight target?

Quads:

• Eachine Shadow Fiend 4" PNP with Crossfire nano wiring as per this guide