chofchop

I have bench tested EPW6 (ELRS3.3.0) for over 44 hours, and so far I have not had any problems with lost control. When I tried EPW6 (ELRS3.3.2) several times along...

> This is not something that we have been able to reproduce. We have seen similar behaviour before where the firmware was built on windows, and also can occur from...

> This is not something that we have been able to reproduce. Under me, this problem occurs with MT12, X9Lite, and all three EPW6. It is highly unlikely that this...

In the previous tests, the ESC (BL-SP4) was connected to ch1 of EPW6, the servo (JR DS3405) was connected to ch2, and the receiver power was supplied from the ESC....

Thank you for testing. I am also continuing to test, but the problem does not occur with EPW6 (3.3.0), but the problem occurs when I change to 3.3.2. After this,...

To confirm that it was a hardware issue specific to EPW6, I changed the receiver to EP1tcxo (I don't have any other PWM receivers other than EPW6). As a result,...

Testing continues, but only a portion of it has been completed as there are a huge number of combinations. 333Hz is also essential for me, so I'm thinking of narrowing...

Thank you for finding the cause. This information may not be necessary anymore, but in my testing, the higher the servo frequency, the more frequently the problem occurred. At 50Hz,...

>Works correctly on the shipping MT12 firmware as well in my testing Hello. I also have no problems with the 1b7044a firmware (January 17th). I'm converting my display to OLED,...

After deleting radio.yml, normal operation returned. When I restore the backed up radio.yml, the problem occurs again. I'll do a little more research to find out what the problem is.