chofchop
chofchop
If you don't mind, could you please tell me the purpose?
Thank you for answering. You're talking about Trim's name. What do you think about the physical and on-screen positions of T1 and T2 being flipped horizontally? Was this also done...
Thank you, I understand. But I'm very disappointed.
This is off-topic, but regarding the matter I said "I'll explain later" above. For RC cars, it may be necessary to move the neutral position of the throttle (drag brakes,...
I basically use 3.75MHz, but I also tried 1.87MHz and 5.25MHz, but there was no improvement.
  
I am flashing and trying an EP1/2 tcxo and a BetaFPV nano receiver as TX. Unfortunately I don't have an ESP32 receiver. As mentioned before, I get frequent "telemetry lost,...
> Just increase the UART speed for the internal module. Are you talking about the baud rate? As far as I understand, anything above 1.87M is fine.
I first suspected a poor contact in the wiring and collector of the internal module, but after seeing that the problem did not occur with the v3.3 firmware, I began...
> The ESP8285 is old and is nearing Espressif end-of-support. The ESP32C3 is the replacement going forward. Using an RX as a TX is a convenience not that something that...