Robo Durden

Replace with a GD32F130C8T6: https://www.aliexpress.com/item/1005006091456025.html But you would still need to trace the pins on your new layout. Better buy some other hoverboard that is as old as possible. Then...

I also already thought if increasing the amps as I drive 1000 Watt scooter motors for my log band saw.. Easiest way is to simply double the MOSFETs by soldering...

There is a 30k : 2k voltage divider to reduce the 40V to below 3.3V:  Try adding another 30k in parallel so a lover voltage will still trigger the...

It would need a complete rewrite of bldc.c But I think when connecting the yellow wire to the plus pole of each brushed motor and the blue and green wires...

https://youtu.be/D_PfKFIc_kc

You set a positive speed that you can pedal. With torque mode it might be a negative torge. With my pedal crank I can easily generate 1A at 25V. 2A=50W...

Building a stand for the bike might be more hassle than adding such a freewheel sprocket to a hoverboard motor: https://youtu.be/ux3u7hCExMk You could also keep the back wheel when inserting...

With a 26 inch wheel bike and pedaling 25 kmh you reach 200 rpm. Simply pushing a 6.5 inch hoverboard wheel onto the 26 inch wheel will make it spin...

Arduino Nano and software serial need 19200 baud, 115200 is to much !! Better go with an esp32 S2 mini :-)

Better go with esp32 as it has three hardware serial ports. Arduino nano only has one and you have to disconnect when flashing Arduino. I drive my solar car with...