Mrnt
Mrnt
Presumably there was something in the G-code file that pre-heated T0 to 180 and then increased it to 240 since there is nothing in the log to indicate a command...
@mefistotelis Do you think that the MPU-6600 has X/Y/Z accell/gyro self test registers like the MPU-6500:  [https://invensense.tdk.com/wp-content/uploads/2015/02/MPU-6500-Register-Map2.pdf](url) It looks like these may...
In the ReadMe in the section Printer Compatibility it says not compatible because there is no USB port. You are welcome to help develop and debug ethernet support for it...
Sorry for the late response. The USB connector on the front is for plugging in a USB flash drive - the printer uses this port as a USB "host" and...
Sorry for the delay in responding. I do not think the Adventurer 4 will work because it only has a USB port for a USB drive - ie it can...
@chessdenman I doubt FlashForge will abandon their printer line - they keep on making more with seemingly the same closed source code base. They do however stop supporting old versions...
@moonglow line 2977 in configuration.h needs to be enabled: `//#define NUM_M106_FANS 1` I just verified this. It looks like marlin assumes there is a part cooling fan for each head...
Will take a look
Looks like making a second dummy fan for the same fan does not work, ie FAN_PIN = real cooling fan, FAN1_PIN = FAN_PIN, FAN2_PIN as chamber fan - I can't...
Reading through the bug reports in Marlin related to chamber fans it appears that `M106` is meant only for part cooling - if you want to control the chamber fans...