Mrnt

That would be great if you are willing to have a look! Hopefully you can capture something meaningful between the printer and FlashPrint on ethernet traffic. Otherwise, another user was...

Thanks for that (and pulling it into a single text file) - very helpful to see what is being sent and received. Also there is a command I have not...

Ugh sorry about that - I was basing it on what you observed from FlashPrint, which looked like it was sending the number of stepper motor steps rather than mm...

> it was little hard to follow everything at the same time, but it looks like flashprint sends ~G1 Z-1000.000 F800.000 hvem you hit the arrow in control panel to...

Yes, I was thinking the way you outlined ie `G91` becomes `G90, M114, G1 `. Kind of a pain, but maybe I can do something not too hacky using the...

I think I almost have a solution for the (G91 relative) movement not working - Question: if it was an option in the printer profile to enable a work around,...

@rmhalvorsen I have added some functionality to the development branch to support this printer via a checkbox under the Axes tab of the printer profile. You can install the development...

Did you find and enable this control: With the above enabled, what you should see in the OctoPrint log after clicking a move button is: ``` FlashForge.write() M90 ... FlashForge.write()...

Thank you for your log and patience - I'm debugging this blind so that is helpful. I don't think it likes the M400 (wait for movement to finish) command. I...

Did you: - check you had set up all the settings as described in the install/setup guide for the plugin? - turn on debugging as described in the troubleshooting notes...