Mrnt
Mrnt
I just made it separate section for it in the README
When you say it doesn't work, can you describe what is happening? I see that the status messages sent by the printer are different from the other printers, so that...
> When I hit print, the z axis motor activates and appears to be trying to pull the bed downwards and since the bed is already at the lowest point,...
if you try: `G28 X Y Z` what happens?
Did it move at all?
Typically it is the Z axis that is inverted. But that setting is just for the purposes of the "Control" tab on OctoPrint which uses relative positioning - ie if...
I am concerned that sending `G28` to the printer using the terminal window has no effect. Presumably hitting the 'home' buttons on the "Control" tab also have no effect? If...
Unfortunately the older printers do not provide a list of what is on its SD card, so I stopped sending the request to the printer (I doubt the 3D40 supports...
Ah I see the problem. The status reporting in response to the M119 command is quite different from the other printers I have looked at, so the code is not...
I made a branch with some code to try to accommodate the response from the Dremel. You can test it by loading it into OctoPrint: 1. Go to **Settings** >...