Mrnt
Mrnt
Note that you have to use the "Upload to SD" button - the direct print from OctoPrint method where you load the file into OctoPrint and then select it from...
Oh you may be right. I have not looked at OctoLapse to see whether it takes images based on time or whether it depends on OctoPrint knowing what layer is...
Can try the latest build and: 1. connect to the Guider 2. allow control of the X, Y, Z axes INCLUDING the Home buttons 3. upload a file to the...
That's really cool! Congrats!
@visualvalhalla thanks for pulling this together and sorry for the delay in responding - have been busy. Have you tried all those commands on your Dremel to make sure they...
Can you connect OctoPrint to the Finder while the printer is in idle state, then in OctoPrint: - click the X/Y home button once and wait for any movement to...
so `G28 X Y` will not work? After ``` G28 X G28 Y G28 Z ``` are you able to step X, Y, Z successfully?
Interesting. Couple of ideas: - Have tried controlling from FlashPrint to make sure it is not something an issue with the printer firmware: ![Screen Shot 2020-05-21 at 10 14 17...
Thanks for that information re FlashPrint. I'm not sure, but I'm thinking `M601 Received. | Control failed. | ok |` may be related to the issue. I am not sure...
Can you verify if the other controls are working - lights, extruder, setting temperature? I will update the ReadMe to reflect this is not working until I figure it out.