InsanityAutomation

@shadow578 Is this still in a good state in youre opinion? Was looking at getting the Tenlog HC32 board ported in soon and it does seem to call in some...

I'm not a bare metal side expert on the underlying platforms, so I requested Jason review. I don't see anything that jumps out as wrong to me, but he's the...

A dev working for Dagoma used to be active on discord a few years back. I sent him a ping to see if he was still active and/or employed there...

Orel confirmed on discord that the naming was retained from a prototype board and everything matches, so just the env call to adjust.

@0r31 It appears at a glance to be a limited implementation of what mega2560ext has, as it likely predates it, with just what they needed. Id like to see if...

1 more hindsight thought here... The TMC slave addresses are sometimes in configs sometimes in pins... Should we move this one to the pins file to simplify things for end...

Theyre soldered on, so when the board is defined... immutable. Thats when I support setting them in pins file. `#define X_SLAVE_ADDRESS 0 #define Y_SLAVE_ADDRESS 1 #define Z_SLAVE_ADDRESS 2 #define E0_SLAVE_ADDRESS...

When I originally wrote quad z support, a company had offered a machine for testing. I did what exists as a draft with no hardware on hand... It apparently was...

Its actually not that uncommon to see rates well over that nowadays. Im more than happy to test changes against a 1.2m machine with nema23's and 5160s capable of moving...

Do you mean G84? https://gcodetutor.com/fanuc-training-course/g84-tapping-cycle.html