InsanityAutomation

I use maple for development on these boards, then once im done with debugging functions test if it still works ok on stm32.

Thats the range for the Z direction only. X/Y are bound by the ##_MIN and ##_MAX positions.

This exists and now there is a hysteresis to throw out results that differ too much. This can be closed.

Its been awhile, but the extra_probing bit is only a few days old. /** * Multiple Probing * * You may get improved results by probing 2 or more times....

No, it applies during G28 as well.

At a quick read of the code, it seems to have G28 trigger bump for a second hit not actually looping using the number since it sets just as a...

No, it'll move the top surface as well depending on temp probed at, soak time and potentially other variables.

Z_MIN_POS can be useful to allow a nozzle below Z in cases where a wiper pad is installed off the bed to the side, parking or probe/tool stowing and other...

On idex systems, a value below 0 is actually required in conjunction with a manual home position in order to allow tool offsets to function.

> Are there any slicers that generate gcode for a negative Z plane? No, it came about a couple years ago when it was more strictly enforced, and prevented the...