0crap
0crap
> Try clicking the "Flush settings cache" button in the main application settings box, Also restart Configurator after flashing and flushing the settings cache. This could work as a temporary...
Same here, including a full link loss, which is even worse. (v3.5 RC2) Nothing special like the OP with RX_as_TX. Just simple setup with LoRa mode that works without a...
Same here, definitely a regression vs 3.5.4 Tested on my QX7S and EP1. (150hz/std/wide/normal)
Any reason to leave this servo filter type as a BIQUAD? BF as well as INAV v8 use a PT1 for the gyro anti alias filter. If it's good enough...
I bench tested two planes for jitteriness on the bench. Zero difference with servo_lpf_hz = 400 vs default. One cheap set of analog servos set at 50Hz PWM. One nice...
I tested this today on my AR.Wing 900 in flight. It uses cheap analog servos running at 50 Hz. Tested doing a full stick roll in acro mode. Used the...
> I'd assume you'd want to keep the CLI variable for the servo LPF still a 0-400, but you'd add an if statement for if servo LPF is set to...
And tested with servo_lpf_hz = 0 (effectively switching the filter OFF) No problems in flight. (Also not on the bench.) Still clean servo traces in BBL. Time difference between PID_sum[roll]...