0crap

Check. So for sure you got a failsafe there.

> Out of interest, if you do use the Aux channels for LQ or RSSI, does that mean they aren't available for anything else, e.g. switches/pots ? Not obvious how...

> Ok, but I still don't understand what could have happened, without the tx log it is not easy to understand. I was in dynamic power with the tx module...

> > > > AUX11 changes immediately instead. With the tx two meters away from the rx the sensor RSS1 on the tx it is at -50, and AUX11 seems...

Same here, no PIT mode on a Rush TANK 5.8GHz VTX. Using iNav 2.6.0 Alfa2, VTX uses TBS SmartAudio V1.

Seems like a perfect solution for this issue #8200 I'm not a coder but I'll give it a try to see if I can compile a hex on top of...

Crap, I'm stuck, copy and paste shows a difference in src/main/flight/pid.c on[ line 774](https://github.com/iNavFlight/inav/blob/master/src/main/flight/pid.c#L774). When the original PR was created this was not there before. `const float rateTarget = getFlightAxisRateOverride(axis,...

Got something compiled based on v4.1.0. 💯 If my wing does not fall out of the sky I can get in some results! I have no idea what "OSD with...

Results are in, just back from the field!  Unfortunately it's not an improvement yet. I tested mostly rolls and a few loops. At the end of the roll there...

Tested on my DIY 2.4 TX. Works nicely. This is a great addition for manufacturers. The debug mode `-DDEBUG_FREQ_CORRECTION` is more towards the advanced end users as I look at...