0crap

OK, well, I have nothing more besides the OSD data I used to render the YT video linked above.

What I understand from the Discord discussion is that OTX logging should continue nonetheless. Because I have some logic tied to OTX logging, also depending on telemetry, that must be...

Yep, already done. :-)

Sorry, not yet. I'm away from my gear until after the weekend. I'll report back next week.

I tested this a bunch of times on the bench. Connect/disconnect a RX with some time in between to see if it disconnects. I was not able to reproduce it....

Interesting part is that I have to paste in my "diff all". Only flashing and load defaults is not enough to get the Baro Alt graph moving. In any case,...

> Did you update with full chip erase? Of course, as noted in the opening post. Added the FC Calibration step as well in the opening post for a 100%...

> Altitude in 8.0 is held essentially at 0 until first arm so it won't change until you've armed. I think vertical acceleration will have some affect before first arm...

@breadoven I read your reply a few times. As you can see the blue line moves fine when firmware v7.1.2 is installed.  As soon as I flash...

Same here, usually clicking the Disconnect/Connect button a few times solves the issue. Does not happen with the 7.1.2 Configurator. [Matek F405-STD](https://www.mateksys.com/?portfolio=f405-std)  For me it pretty much happens always...