wernerdaehn

Implementation is probably simple. Need to find a spare GPIO pin, PWM output and we are good. But is it worth it? You would need to attach a buzzer. For...

That's an argument for getting feedback. But not if bluetooth or buzzer, is it? Yes, the pins are not used at the moment.

Hardware looks good. You are you connected with the CC3D you said and can send commands, yes? Then I would like you to show me the following: - What is...

The output of $d p I don't like. There is no long pause used as indicator for a packet end, some values are negative - how is this even possible??...

The documentation in you link says: > When one of CH1-CH8or some of CH1-CH8 input PWM signal, CH9 will output PPM signal and CH10 output SBUS signal. (LED Indicatorflash 1...

I am skiiing. But the $i output looks good. Yes, move and hold the stick in an extreme position and $i will show a different value for one channel. Am...

Yes, that all looks good. Very good in fact. It seems in the Taranis a mixer is programmed or the stick assigned to multiple output channels. https://oscarliang.com/taranis-mixer-for-wings/ On the weekend...

You can start with heli-mode, which is using a lot of mixers. And then you disable the mixers. It does not matter which mode you start with as default setting....

Yes, this is how a mixer might look like and how you can enable/disable it. But there are other resources like the manuals. You goal is: In the Servo-Display page,...

In that case I see two options a) Try again using the $1 command but make sure you move the stick just up/down and not left/right. I have some tolerance...