diyBMSv4ESP32
diyBMSv4ESP32 copied to clipboard
stuartpittaway
diyBMS v4 code for the ESP32 and new controller hardware
**Describe the bug** If you have lots of errors and warnings its hard to read it because popups constantly shows above this red alert bar. The alerting system should be...
Hi, I was squeezing very last mAh 's from battery. When battery reached 'Battery discharge voltage minimum' setting, Inverter log says 'The battery asked for a forced charge'. Inverter started...
Hello Stuart Somehow the latest firmware has a problem. The SD card cannot be mounted, the communication keeps breaking off. If I want to flash firmware on a module with...
To protect my small children from WLAN radiation, I automatically switch off the WLAN at night. At 6:30am WiFi turns on again. Sometimes the diyBMS could not be reached via...
Is it possible to let the monitor2.json output also go through the serial connection? Maybe with a checkbox enable/disable in the GUI. Then it will be (for example) possible to...
Hi, the battery modules disable their serial transmitters when they're "done". The problem is that the controller does not. This causes an additional constant 1mA drain to the first module....
Ahoy, Stuart. Thanks a lot for sharing this BMS and giving us DIYers a nice option to care for our batteries. I couldnt find any issue about "SMA" or "Sunny...
**Describe the bug** Improving serial speed on attiny. [email protected]
- Rule for Cell Range. - And in our use case, it would also be beneficial to have an additional 'Individual Cell Over Voltage' rule. The reason for dual CellOV...
I set the relay type to "pulse" and the relay default to "on". This works during normal operation. But when the controller is reset, the relay signal is permanently on....
Metadata
Owner
Metadata
diyBMS v4 code for the ESP32 and new controller hardware