diyBMSv4ESP32
diyBMSv4ESP32 copied to clipboard
stuartpittaway
diyBMS v4 code for the ESP32 and new controller hardware
Hi Stuart, What I'm proposing would 'simply' be another button on the 'Modules' page, similar to 'Identify', which could be setup to tell an individual module to 'dump' a configurable...
Since it took me few days to figure out how to make the SD Card work, I'd like to suggest to put some info on the SD Card settings page...
I would like to be able to change the values in 0.01v or 0.05v steps in the display settings.
The CPU frequency could be reduced to save power. Especially for (my) offgrid application where there is sometimes no charge current for months, the self-discharge due to the controller consumption...
hi, When setting up diyBMS it comes with 18650 battery profile presets. Whoever uses fe lifepo4 must edit all rules/balancing etc values. OK, you edit once and assuming you have...
Hello Stuart, I would like to suggest/request a new feature for rules / relays. It would be nice to have an ON and OFF delay for each relay (below, where...
Particularly, the “Rules” page does not work well on my tablet in horizontal view. Or on my phone in vertical view. So I have to rotate both - on that...
@stuartpittaway we've (vaguely) discussed that before in another thread on the forum without a final conclusion (I think!). Anyway, I'm now trying to finish off the installation by connecting the...
I've been doing some tests on an 8S LiFePo4 pack of which one battery is a bit worse than the others: it holds ~20% less charge. What I've found is...
On power up of the controller on IDF 4.4 framework, the below errors are reported. System functionality doesn't appear to be affected by this and looks like an issue with...
Metadata
Owner
Metadata
diyBMS v4 code for the ESP32 and new controller hardware