diyBMSv4ESP32

diyBMSv4ESP32 copied to clipboard

Dashboard get very crowded with more cells.

5

**Hardware/Software Versions** Controller version (from PCB): Controller V4.6 & AllInOne V4.90 (below can be obtained from the "About" page in the controller web interface) Version: Release-2023-12-27-12-02 Hello, is there any...

Ipirk88

Identifying which battery bank I am looking or working on?

1

I have a few battery banks running and have to double check which battery bank I am viewing or changing settings, I think a need for a editable descriptive title...

rosspeel

Low battery voltage if wifi disconnected.

22

**Describe the bug** If the wifi connection is lost the controller reports to my victron that the battery voltage is low. **Hardware/Software Versions** Controller version (from PCB): 4.5 Host name:...

Linusten

Suggestion improve Cell runaway function

6

at the moment the 4.9 all in one module balances only one cell after an other, but it should balance all cells at same time if they are over the...

red0909

Enhancement Proposal: Internal BMS Error Handling for Enhanced Safety

1

I also identified a critical aspect that requires immediate attention for the sake of system safety and reliability. The concern pertains to the handling of Internal BMS Errors, specifically when...

lorenzo6201

Temperature display 16S balancer

5

Hello everyone. I have a strange phenomenon. When I plugged in the balancer module, every second cell shows minus temperature. This is the case with 2 modules on the same...

gartenjoe

add MQTT Input frame usable external Current-Sensor

7

I want to experiment in using the bat data from the Charger to "simulate" the current sensor from the BMS. I'd like to send via MQTT values like: current, charged-Ah,...

Bingo2023

Enhancement Proposal for Current Monitoring Overcurrent Rule

2

During my recent exhaustive testing of the controllers, I came across a notable observation regarding the Current Monitoring Overcurrent (Amps) rule. While undoubtedly beneficial, it appears to lack a crucial...

lorenzo6201

Add Modbus TCP

3

As the controller is already equipped with an Ethernet-connection threw WiFi, it would be great to have an read- out and -in (DVCC values) over Modbus TCP. I’m actually building...

Chris87-ux

I was testing some firmware with meningd and noticed that the controller does not send the appropriate alarms to the inverter. No mater what fault condition I trigger the controller...

lorenzo6201