Stuart Pittaway
Stuart Pittaway
I've not found a reference manual as such, there is a link in my source code to the site where I found most information from. On 19 September 2016 at...
Happy to take a look. On 19 September 2016 at 10:51, Bo Herrmannsen [email protected] wrote: > oki, wil try and have a look > > when i come up with...
Yes I think you are correct, not 100% following, but I think you are on the right lines. On 20 September 2016 at 14:51, Bo Herrmannsen [email protected] wrote: > or...
Hi Rob, my wiring diagram is on Github as well. https://github.com/stuartpittaway/WebastoWBUSInterface On 11 October 2016 at 12:29, Rob Aldred [email protected] wrote: > @boelle https://github.com/boelle thank you ever so much for...
Hi. Unfortunately I don't have any spares for the current shunt - as you mention, the parts are almost impossible to obtain at the moment. I don't have much experience...
The current shunt on diybms will only tell you whats going in and out of the battery, but that won't give you the load on the house/grid.
@allanlind have you tried your Victron setup on the latest version of the DIYBMS code (both controller + shunt) ?
I'm not sure about using zeros in settings for the relay. Are you using the latest firmware on the shunt board?
Ok, needs to be investigated more thoroughly, but I'm not near a computer for a few days now. Just for information, what are you running from the shunt relay?
Ok, don't forget the relays on the controller can also do that for you!