Mark Burton
Mark Burton
Hello @MeirionHughes , the changes are trivial.... This is added to the travel section in fdmprinter.def.json ``` "travel_no_combing_on_initial_layer": { "label": "Disable combing on the initial layer", "description": "Disabling combing on...
Hi, sorry for the late response. My Cura build for today (1124) allows you to set the Brim Distance value per-mesh. That was easy to implement and I hope it...
> I guess this works as a workaround if I specify the brim distance to be large enough to disconnect it from the model. Thank you! The whole point of...
> Being able to completely disable brim per mesh would be ideal. Sure, but that's yet another setting. One of the reason that the Cura UI is so sluggish is...
Good point but as you can't give an individual mesh either the raft or skirt settings without doing a lot of work in the slicer it's not possible to make...
Hi, I found a problem with the brim distance feature on the 1124 release, please use 1125 instead. Sorry for the inconvenience.
Do you have extruders share heater option enabled in the printer setup? Enabling that should zap the extra M10[49]s.
I tried loading your project but it didn't load OK so I can't slice your project, sorry.
Hi Andy, thanks for that, I believe you're right, the temps need to be the same for all of the extruders.
Yes but here there is only one hotend so all the extruders need to have the same printing and standby temps to avoid waits.