Mark Burton
Mark Burton
Ah yes, it was discussed in https://github.com/Ultimaker/CuraEngine/pull/1422 where @Ghostkeeper didn't like something so the fix never got used. Hard luck...
The original fix was https://github.com/smartavionics/CuraEngine/commit/f4b96769ad29971c92fce33c9a59cbe102b45f36
I'm truly sorry that your printer was broken by my bug. I did try to get a fix for the bug into UM Cura as soon as I discovered the...
My Cura build does partition skin regions depending on whether they are above air or not. It does this so that it can optimise the direction of the skin lines...
> Does it do it for bridge walls too? Those matter a lot more in some sense for under/over extrusion of the non-bridge part. I don't understand your question as...
See https://github.com/smartavionics/Cura/releases for a Cura variant that already does what you're requesting...
The reason it is jumping about like that is because it is filling in the odd gaps first and then later on it prints contiguous areas. You can see that...
See https://github.com/smartavionics/Cura/releases for a Cura variant that provides this feature. It has a Cooling Fan Lag setting that lets you specify how long it takes for the fan to spool...
With regard to filling in the little holes in the peaks of the gyroid infill, I've been doing some experiments. I can now reliably get it to produce infill that...
> How do the extrusion paths look? Does it extrude lines on one diagonal, then the other, bridging the gap, but crossing paths? Or is it still running X/Y and...