rusefi

Hall input: do we need R18=R19=4.7K? keep C12 & C35?

5

Would TLE8888 in Hall mode allow us to drop R18=R19 altogether? In order to reduce HW difference between hall and VR modes can we keep C12 & C35 while running...

water proof USB connector right on the case

5

Different approach to #145

Maybe go back to original USB connector

17

0.1 to 0.4.6 we used Molex 105133-0031 with 0.4.7 @DonaldBecker has switched part number to Wuerth 614105150721 see https://github.com/rusefi/hw_microRusEfi/commit/9536feb43b59f3a4bad73cc25390157eb1d7ccad recently we found a compatible USB3131-30-0230-A just with longer leads (and...

JLC orientation drama

1

We need a solution for orientation drama. Each CPL file has it's own orientation differently and each order is the same or similar stress of Q and A from JLC...

IS25WP256D-RMLE is a 1.8V part

3

We are 3.3 so we need IS25LP256D-RMLE L, not W

[test fixture] wiring usability

1

pigtail has many short wires so from mechanical side of things at the moment it's tempting to mount it on the back side of the PCB - this case all...

test fixture: power some low-side LEDs from sensor 5v output

2

don't power all low-side from +12v power some of them from each of the 5v sensor supply outputs from MRE that way we can test two birds with one stone

test board: wire buttons to the analog inputs

4

@mck1117 says "one idea I had for a test board I had: wire buttons to the analog inputs, and LEDs to outputs. Write firmware that just reads inputs and writes...

test fixture: buttons should have through-hole option or same as MRE

6

at the moment text fixture uses some unique button footprint let's share footprint with MRE or better allow through-hole option. I suspect that my through-hole push buttons are 0.2x0.2 inch...

test fixture: LEDs for all GPIO

1

we need traces/vias/LEDs for all GPIO outputs J9 J10 etc