PrusaSlicer
PrusaSlicer copied to clipboard
prusa3d
G-code generator for 3D printers (RepRap, Makerbot, Ultimaker etc.)
### Description of the bug Any file that i try to slice, just top the print in the first layer, after the skirt. This was testes with two different printers...
### Description of the bug When auto-generating organic supports, several 90° overhangs are completely ignored. Using standard supports, they get supported. Also, the support base is just 2 walls on...
### Description of the bug Trying to slice a model with different infills and pattern, bugged on 2.6 alpha, but ir's ok on the 2.5 version. Slicing at 25% gyroid...
### Description of the bug Not possible to use raft with organic supports ### Project file & How to reproduce Slice ### Checklist of files included above - [ ]...
### Description of the bug When I rotate a non-square box 90 degrees, it doesn't change the height to width & vice versa. It should rotate the box. It should...
### Description of the bug I get the error "PressureEqualizer: Error parsing a float" when I try to slice any model with an overhang. This happens as soon as I...
### Description of the bug As the name states, when the type of supports is set to organic, and the setting for "no supports for bridges" is set to "on",...
Hello! I've created a vendor profile for all of MakerGear's printers, nozzle types, and different printing modes (like duplication). I've been using these for the last couple of months and...
### Version 2.4.1 (tested 2.3.3 and 2.4.0 as well) ### Operating system type + version MacOS Big Sur 11.3.1 ### 3D printer brand / version + firmware version (if known)...
### Description of the bug The print starts here in the air, if it would start properly at the print part then one could print very well in the air...
